Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- geraetschaften:cnc-fraese:grbl-konfiguration [2017-09-17 21:31] – angelegt raketenolli
+++ geraetschaften:cnc-fraese:grbl-konfiguration [2022-11-17 22:34] (aktuell) – Externe Bearbeitung 127.0.0.1
@@ Zeile 1: / Zeile 1: @@
-====== GRLB-Konfiguration ======
+====== GRBL-Konfiguration ======
 <note warning>Diese Seite nicht verändern!</note>
@@ Zeile 5: / Zeile 5: @@
 <note warning>Diese Einstellungen in der Firmware nicht verändern!</note>
-''A
+  $0=10 (step pulse, usec)
-B
+  $1=25 (step idle delay, msec)
-C''
+  $2=0 (step port invert mask:00000000)
+  $3=0 (dir port invert mask:00000100)
+  $4=0 (step enable invert, bool)
+  $5=0 (limit pins invert, bool)
+  $6=0 (probe pin invert, bool)
+  $10=3 (status report mask:00000011)
+  $11=0.010 (junction deviation, mm)
+  $12=0.002 (arc tolerance, mm)
+  $13=0 (report inches, bool)
+  $20=0 (soft limits, bool)
+  $21=1 (hard limits, bool)
+  $22=0 (homing cycle, bool)
+  $23=0 (homing dir invert mask:00000000)
+  $24=25.000 (homing feed, mm/min)
+  $25=500.000 (homing seek, mm/min)
+  $26=250 (homing debounce, msec)
+  $27=1.000 (homing pull-off, mm)
+  $100=66.667 (x, step/mm)
+  $101=66.667 (y, step/mm)
+  $102=2560.000 (z, step/mm)
+  $110=2500.000 (x max rate, mm/min)
+  $111=2500.000 (y max rate, mm/min)
+  $112=500.000 (z max rate, mm/min)
+  $120=25.000 (x accel, mm/sec^2)
+  $121=25.000 (y accel, mm/sec^2)
+  $122=10.000 (z accel, mm/sec^2)
+  $130=200.000 (x max travel, mm)
+  $131=200.000 (y max travel, mm)
+  $132=200.000 (z max travel, mm)